General F.A.Q

▶ Q. How thick are your countertops?

A. 2 cm (about 3/4" of an inch) with a 4 cm (about 1 1/2") laminated edge.

▶ Q. How much overhang do I need to allow where there are finished edges?

A. 2 inches.

▶ Q. How exact do I have to be in my measurements?

A. The greater the accuracy the better the ultimate fit and the easier the installation. Try and get within at least 1/4 inch. The manner in which the counters are constructed does allow for some play and error. The back and side splashes allow about 3/4 of an inch under which problems can be hidden. The manner in which we make the corner panels also allows for a wide margin of error.

▶ Q. How do I get a quotation?

Just fax a dimensioned sketch to 905 692-1828 and in 24 hours you will receive a hardcopy quote back from our estimating and pricing department. These are not the final measurements that will be used so you don't have to worry about being exact at this time. After you place your order you will get a set of dimensioned engineering drawings. You will have an opportunity to make any adjustments or corrections to the measurements when you get the drawing. We don't start fabrication until we have a set of endorsed drawings from you. If you are using an independent installer, contractor or cabinet maker it is usually a good idea to get them to check and approve the drawing so if there is any problem with the measurements they own the problem not you.